Read the information concerning the safety technologies of vehicles and try to summarize it using a plan.

 

Manufacturers continue to build lighter vehicles with improved structural rigidity and ability to protect the driver and passengers during collisions.

Bumpers evolved as rails or bars to protect the front and rear of the car’s body from damage in minor collisions. Over the years, bumpers became stylish and, in some cases, not strong enough to survive minor collisions without expensive repairs. Eventually, government regulations required bumpers designed to withstand low-speed collisions with less damage. Some bumpers can withstand 4-km/h (2.5-mph) collisions with no damage, while others can withstand 8-km/h (5-mph) collisions with no damage.

Modern vehicles feature crumple zones, portions of the automobile designed to absorb forces that otherwise would be transmitted to the passenger compartment. Passenger compartments on many vehicles also have reinforced roll bar structures in the roof, in case the vehicle overturns, and protective beams in the doors to help protect passengers from side impacts. Seat belt and upper-body restraints that relax to permit comfort but tighten automatically during an impact are now common. Some car models are equipped with shoulder-restraint belts that slide into position automatically when the car’s doors close.

An air bag is a high-speed inflation device hidden in the hub of the steering wheel or in the dash on the passenger’s side. Some automobiles have side-impact air bags, located in doors or seats. At impact, the bag inflates almost instantaneously. The inflated bag creates a cushion between the occupant and the vehicle’s interior. Air bags first appeared in the mid-1970s, available as an optional accessory. Today they are installed on all new passenger cars sold in the United States.

Air bags inflate with great force, which occasionally endangers a child or infant passenger. Some newer automobile models are equipped with switches to disable the passenger-side air bags when a child or infant is traveling in the passenger seat. Automakers continue to research ways to make air-bag systems less dangerous for frail and small passengers, yet effective in collisions.

 

Match the meanings of the following words.

 

1. shoulder-restraint belts

2. air bag

3. tighten

4. collisions

5. overturn

6. bumper

7. low-speed collisions

8. damage

9. passenger compartment

10. hub

 

1. столкновения;

2. повреждение;

3. ступица (колеса), втулка

4. подушка безопасности;

5. перевернуться;

6. салон автомобиля;

7. ремни безопасности, ограничивающие движение корпуса;

8. натягивать(ся);

9. мало-скоростные столкновения;

10. бампер.

 

 

Unit VIII

Supplementary reading.

History

 

The history of the automobile actually began about 4,000 years ago when the first wheel was used for transportation in India. In the early 15th century the Portuguese arrived in China and the interaction of the two cultures led to a variety of new technologies, including the creation of a wheel that turned under its own power. By the 1600s small steam-powered engine models had been developed, but it was another century before a full-sized engine-powered vehicle was created.

In 1769 French Army officer Captain Nicolas-Joseph Cugnot built what has been called the first automobile. Cugnot’s three-wheeled, steam-powered vehicle carried four persons. Designed to move artillery pieces, it had a top speed of a little more than 3.2 km/h (2 mph) and had to stop every 20 minutes to build up a fresh head of steam.

As early as 1801 successful but very heavy steam automobiles were introduced in England. Laws barred them from public roads and forced their owners to run them like trains on private tracks. In 1802 a steam-powered coach designed by British engineer Richard Trevithick journeyed more than 160 km (100 mi) from Cornwall to London. Steam power caught the attention of other vehicle builders. In 1804 American inventor Oliver Evans built a steam-powered vehicle in Chicago, Illinois. French engineer Onésiphore Pecqueur built one in 1828.

British inventor Walter Handcock built a series of steam carriages in the mid-1830s that were used for the first omnibus service in London. By the mid-1800s England had an extensive network of steam coach lines. Horse-drawn stagecoach companies and the new railroad companies pressured the British Parliament to approve heavy tolls on steam-powered road vehicles. The tolls quickly drove the steam coach operators out of business.

 

During the early 20th century steam cars were popular in the United States. Most famous was the Stanley Steamer, built by American twin brothers Freelan and Francis Stanley. A Stanley Steamer established a world land speed record in 1906 of 205.44 km/h (121.573 mph). Manufacturers produced about 125 models of steam-powered automobiles, including the Stanley, until 1932.

 

Internal-Combustion Engine

Development of lighter steam cars during the 19th century coincided with major developments in engines that ran on gasoline or other fuels. Because the newer

engines burned fuel in cylinders inside the engine, they were called internal-combustion engines.

In 1860 French inventor Jean-Joseph-Étienne Lenoir patented a one-cylinder engine that used kerosene for fuel. Two years later, a vehicle powered by Lenoir’s engine reached a top speed of about 6.4 km/h (about 4 mph). In 1864 Austrian inventor Siegfried Marcus built and drove a carriage propelled by a two-cylinder gasoline engine. American George Brayton patented an internal-combustion engine that was displayed at the 1876 Centennial Exhibition in Philadelphia, Pennsylvania.

In 1876 German engineer Nikolaus August Otto built a four-stroke gas engine, the most direct ancestor to today’s automobile engines. In a four-stroke engine the pistons move down to draw fuel vapor into the cylinder during stroke one; in stroke two, the pistons move up to compress the vapor; in stroke three the vapor explodes and the hot gases push the pistons down the cylinders; and in stroke four the pistons move up to push exhaust gases out of the cylinders. Engines with two or more cylinders are designed so combustion occurs in one cylinder after the other instead of in all at once. Two-stroke engines accomplish the same steps, but less efficiently and with more exhaust emissions.

Automobile manufacturing began in earnest in Europe by the late 1880s. German engineer Gottlieb Daimler and German inventor Wilhelm Maybach mounted a gasoline-powered engine onto a bicycle, creating a motorcycle, in 1885. In 1887 they manufactured their first car, which included a steering tiller and a four-speed gearbox. Another German engineer, Karl Benz, produced his first gasoline car in 1886. In 1890 Daimler and Maybach started a successful car manufacturing company, The Daimler Motor Company, which eventually merged with Benz’s manufacturing firm in 1926 to create Daimler-Benz. The joint company makes cars today under the Mercedes-Benz nameplate.

In France, a company called Panhard-Levassor began making cars in 1894 using Daimler’s patents. Instead of installing the engine under the seats, as other car designers had done, the company introduced the design of a front-mounted engine under the hood. Panhard-Levassor also introduced a clutch and gears,

 

and separate construction of the chassis, or underlying structure of the car, and the car body. The company’s first model was a gasoline-powered buggy steered by a tiller.

French bicycle manufacturer Armand Peugeot saw the Panhard-Levassor car and designed an automobile using a similar Daimler engine. In 1891 this first Peugeot automobile paced a 1,046-km (650-mi) professional bicycle race between Paris and Brest. Other French automobile manufacturers opened shop in the late 1800s, including Renault. In Italy, Fiat (Fabbrica Italiana Automobili di Torino) began building cars in 1899.

American automobile builders were not far behind. Brothers Charles Edgar Duryea and James Frank Duryea built several gas-powered vehicles between 1893 and 1895. The first Duryea, a one-cylinder, four-horsepower model,

 

looked much like a Panhard-Levassor model. In 1893 American industrialist Henry Ford built an internal-combustion engine from plans he saw in a magazine. In 1896 he used an engine to power a vehicle mounted on bicycle wheels and steered by a tiller.

 

Early Electric Cars

 

For a few decades in the 1800s, electric engines enjoyed great popularity because they were quiet and ran at slow speeds that were less likely to scare horses and people. By 1899 an electric car designed and driven by Belgian inventor Camille Jenatzy set a record of 105.8810 km/h (65.79 mph).

Early electric cars featured a large bank of storage batteries under the hood. Heavy cables connected the batteries to a motor between the front and rear axles. Most electric cars had top speeds of 48 km/h (30 mph), but could go only 80 km (50 mi) before their batteries needed recharging. Electric automobiles were manufactured in quantity in the United States until 1930.